Jump to content
Ventilation & Flow Simulation Forums

Florian Michelin

Moderators
  • Posts

    100
  • Joined

  • Last visited

2 Followers

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

Florian Michelin's Achievements

Enthusiast

Enthusiast (6/14)

  • Conversation Starter
  • First Post
  • Collaborator Rare
  • Week One Done
  • One Month Later

Recent Badges

  1. Hi, sorry for the delay, use the custom junction option. Note that if you have the flow at which this loss occur, you should try to use a resistance instead.
  2. Hi Ivan, Live event are currently restricted apart for Canada and Australia where our team members can travel. But we can organise online training anytime. Where are you based? Regards,
  3. Hi, The gas and pressure from blasting are 2 different simulation in Ventsim. The pressure one is setup from the fire tab by entering a blast pressure and launched from the fire tab. Keep in mind it is only available in Premium. Let me know if this works. Regards, Florian
  4. Hi, This is a bit complicated as, Ventsim typically doesnt simulate flow in dead ends, even when using a duct, the simulation assume that past the end of the duct, there is no airflow. However there is a few way you can try. It might depends on the application, what are you trying to achieve: include all the fans in the model or simulating the airflow in the dead end?
  5. Hi Calen, Thank you for leting us know, we will see if it is possible to do it automatically. Florian
  6. It would depend whether the fan has a VFD installed or not. If the fan doesnt have a VFD, I wouldnt recommend changing the fan speed unless trying to display the need for VFD.
  7. Hi Calen, thank you for the notice, we will try to fix it in the next version.
  8. I am guessing you are trying to add it in Pumpsim? I woud recommned asking the manufacturer for a pump curve. Else we can approximate it with the data available. Florian
  9. Hi, Convert any applies to 3D faces. The correct option here would to use convert floor line. However, you should remove the roof lines until after it is done. Could you show us what the result is when using convert floor lines? Also, if possible, we always recommend to use centrelines to create the model which should be available from software which created the floor lines. Florian
  10. Thank you for the feedback, we will try to add a webinar on the topic.
  11. Sorry to hear, try Daniel Sepulveda <Daniel.Sepulveda@howden.com>. Florian
  12. We are currenty planning our next round of webinar and we would love to know what you would like to see in our upcoming free webinar. Let us know here or by email at florian.michelin@howden.com. All our previously held webinar are on our website: https://ventsim.com/webinars/.
  13. We are currenty planning our next round of webinar and we would love to know what you would like to see in our upcoming free webinar. Let us know here or by email at florian.michelin@howden.com. All our previously held webinar are on our website: https://ventsim.com/webinars/.
  14. Apologies for the delay, I missed your previous post. You should contact Thiago Veiga: thiago.veiga@howden.com. I have also infromed him of you request. Florian
  15. The best would be to contact your local Howden agent. Which country are from? I will be able to point you to the right person. Florian
×
×
  • Create New...