Jump to content
Ventilation & Flow Simulation Forums

Scaling and moving a model doesn't quite work right.


Recommended Posts

I used the tool: Tools>Utilities>Scale Airway Coordinates to modify the size of a model since all the coordinates were too large by approximately factor of 3 (feet to meters conversion issue). After doing this I needed to move the model from the mine grid (+10,000' mine grid = 0' absolute): Tools>Utilities>Move Airways. I should be able to type in -10,000ft for the z coordinate to get the elevations to be 10,000ft lower in elevation, however the move doesn't seem to reset from the original scale of the model. I had to type -3048ft in the z coordinate move window to get it to translate by -10,000ft in the model. If the coordinates on a branch say it's at a certain elevation, when you move the branch it should be based on what the model says at that time and not based on a previously used scaling factor.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...