xiao Posted January 20, 2023 Report Share Posted January 20, 2023 Hey there, how can i edit the Duct Parameters like Leakage Porosity or Offset Vertical after setting up a duct? by clicking Edit i could only change basically the size and Friction Factor. thanks. Xiao Quote Link to comment Share on other sites More sharing options...
Martin Griffith Posted January 25, 2023 Report Share Posted January 25, 2023 Hi Xiao, After building the duct you will not be able to change the offset, to do this you need to delete the duct and build it again. You should be able to edit the Leakage Porosity though. First, hit escape to clear your selection, then change to the Select tool and click once on a part of the duct. The whole duct should then select. Then click the Edit tool button, this should open the Construct Duct form, which you can use to modify most of the parameters. Quote Link to comment Share on other sites More sharing options...
xiao Posted January 25, 2023 Author Report Share Posted January 25, 2023 Hey Martin, as you see in the picture, Leakage Porosity is grey and I can not edit it. Quote Link to comment Share on other sites More sharing options...
Martin Griffith Posted January 27, 2023 Report Share Posted January 27, 2023 Hi Xiao, a while ago we made a change so that leakage paths are constructed even when leakage is specified as zero, meaning you can change it later. I would say you are either using a version earlier than 5.4.1.5, or the duct you are modifying was constructed using a version earlier than 5.4.1.5. If you are using a version later than 5.4.1.5, then if you rebuild the duct you will be able to modify the leakage later. You can check your version number under Help | About. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.