Roy Moreby Posted September 27, 2021 Report Share Posted September 27, 2021 Hi All This may be a dumb question but I cannot see the answer in the manual When drawing longwall goaves or hard rock mine stopes, I create a defined profile then draw the airway to length and set the height and width For a goaf, this could be 4,000m long, 300m wide and 150m high - works great. The important issue is how these voids interact or connect to overlying old workings. When using the graphics scaling tool, this alters the height and width but not the length. So, the question is, how do you set scaling so that all airway height and width are drawn 1:1 to match lengths? I noted that when I tap on the icon at the bottom of the scaling tool it appers to go close to 1:1 - is this what it does? Quote Link to comment Share on other sites More sharing options...
Roy Moreby Posted September 27, 2021 Author Report Share Posted September 27, 2021 Sorry - was a dumb question, I forgot about the text at the top of the scaling tool Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.